King Kutter King kutter Lawn Mower 999994 User Manual download pdf (Page 20)

FINISHING MOWER OPERATION

STEP 1

Before each use perform the maintenance described in maintenance section (pg# 21)

STEP2

Read, understand, and follow the information on safety training, preparation, starting

and stopping safety, operational safety, transport safety warning sections of this man-

ual (pages 11 thru 16)

STEP 3

With tractor running, lower finishing mower to ground so that the swivel links are par-

allel to the ground. This allows the free-floating hitch system to follow the contour of

the ground, thus mowing evenly on uneven terrain.

STEP 4

With the tractor at idle RPM, engage PTO and slowly advance throttle to 540 PTO

RPM. NOTE: Finishing mower designed to run at 540 PTO RPM only.

STEP 5

Select a low gear for the tractor and begin to mow. Tractor ground speed

is to be controlled by gear selection only and not engine speed. Tractor

ground speed should allow finishing mower to maintain 540 PTO RPM and

thus maximum blade tip speed.

NOTE: Do not allow the tractor engine or finishing mower to bog down or stall. This

causes undue wear and tear on the mower and tractor. If this continues to happen re-

duce ground speed and raise cutting height of finishing mower. Never attempt to

clean out a plugged discharge chute until the tractor has been shut down and the

mower blades have completely stopped.

STEP 6

After each use clean all debris from the top and bottom of the finishing

mower. Replace any missing or illegible safety decals. Inspect for any dam-

aged or worn parts and replace before next use. Store finishing mower in a

dry environment.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

King Kutter King kutter Lawn Mower 999994 User Manual Page 20