King Kutter King kutter Lawn Mower 999994 User Manual download pdf (Page 17)

ATTACHING TO TRACTOR continued....

STEP 5

Place and hold inner PTO shaft section next to outer section and check if PTO

shaft is too long. Each section should end approximately 3 inches short of

reaching u-joint shield on the opposite section. If the shaft is too long measure

3 inches back from each u-joint shield and mark the other shaft section. Be sure

to do this for both PTO shaft halves. NOTE: Do not cut PTO shaft sections at

this time.

STEP 6

Raise finishing mower and remove blocking. Raise and lower finishing mower in

order to locate the longest distance between equipment input shaft and the trac-

tor PTO output shaft. With the finishing mower in the longest distance position

shut down the tractor and SECURELY BLOCK THE FINISHING MOWER IN

POSITION.

STEP 7

As in step 5 hold PTO shaft sections together and check for a minimum of 6

inches of overlap. If PTO shaft has been marked for cutting the overlap is the

distance measured between the two marks. If the PTO shaft has less than a 6

inch overlap, DO NOT USE. Contact your authorized King Kutter Dealer.

NOTE

If the PTO shaft length is too long go to SIZING PTO SHAFT (pg. 18)

STEP 8

Apply any multi-purpose grease to the outside of the male (inner) PTO shaft

section. Assemble PTO shaft and install on finishing mower and tractor.

WARNING - Failure to install retaining clip on gearbox input shaft would allow

driveline to swing freely if bolt is sheared causing possible injury or

death.

STEP 9

Pull on tractor side of PTO shaft yoke to be sure it has locked in place. Make

certain PTO shaft shielding is in place and good working condition.

STEP 10

The PTO shaft shield is a non-rotating design and must be secured prior to

equipment use. Using the chain on each yoke shield attach to a fixed object

on the tractor and equipment ends that will not allow the PTO shaft shield to

rotate during operation.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

No comments

King Kutter King kutter Lawn Mower 999994 User Manual Page 17